 Most viewed |
|
|
It works ... for a while.2086 viewsAn explanation for those people not doing this sort of work (and for some who are ), the connections should be soldered. If the poles in the epoxy strip haven't been used before (as in the picture), some preparation is required. Remove the coating from the poles, first. Give the poles some solder, second. Wrap the wire around the pre-tinned pole, third. Solder the wire to the pole, fourth.
Or, don't bother at all. Time is money.Magilla
|
|
FTTN compression work1885 viewsPowerpoint presentation of work done for NBN node connection to the copper access network.Magilla
|
|
Thanks to kevinlms for the picture1740 viewsShop fitters at work.
Two pics of a shop MDF in Moorabbin Vic. Note how the display stand support is right in front of the frame, making it impossible to access more than the right 30% of each Krone Strip. All the lines I needed to test were on pairs <6. I found the cover, in the storeroom 15 metres away.
I had to arrange to come back, after the stand had been partly dismantled.
Magilla
|
|
|
|
|
|
Ring & Tone Generator1252 viewsMagilla
|
|
Step-by-Step Exchange1227 viewsMagilla
|
|
Blocked Telstra box 1211 viewsMagilla
|
|
South Brisbane ESA FTTH at Woolongabba Exchange1178 viewsMagilla
|
|
|
| 221 files on 19 page(s) |
1 |
 |
|
|
|
|
|
|
|
|
|
